If you have been reading about sublimation and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Last reviewed on 2025-10-25. Where a claim depends on a specific study, the study is described rather than over-claimed.
A typical cycle begins with freezing, sometimes including an annealing step to control ice crystal size. Freezing conditions influence the pore network that later allows vapor escape. During primary drying, shelf temperature and chamber pressure are set so heat enters the product while its temperature stays below the collapse or eutectic point. Secondary drying then raises the shelf temperature to desorb bound water and lower residual moisture. Cycle design depends on formulation, fill volume, container type, and equipment capability.
The physics of lyophilization couples heat transfer, mass transfer, and phase behavior. Sublimation requires a vapor pressure difference between the ice front and the chamber, and the dried layer adds resistance to vapor flow. Amorphous formulations are characterized by a glass transition temperature of the maximally freeze-concentrated solute, often denoted Tg'. Crystalline bulking agents can provide structure, while amorphous excipients stabilize labile components. Open questions remain about spatial heterogeneity, edge effects, and how laboratory cycles scale to production.
The physics of freeze-drying couples heat transfer, mass transfer, and phase change. Heat supplied through the shelf must reach the sublimation front without melting the ice or degrading the product. Water vapor then travels through the already dried layer and leaves the chamber, where low pressure and cold traps keep it from returning. The dried layer acts as a resistance to vapor flow, so drying rate changes as the front recedes. Open questions remain about how pore structure and formulation heterogeneity affect drying uniformity at larger scales.
Lyophilization removes water from a frozen material by sublimation under reduced pressure. The process begins with freezing, which converts liquid water into ice and concentrates dissolved solids. Primary drying then lowers chamber pressure so ice changes directly into vapor without passing through a liquid phase. Secondary drying raises the shelf temperature to remove bound water that remains after ice sublimation. The result is a dry, porous structure that can be reconstituted later.
Formulation composition influences whether freeze-drying produces an intact cake or a collapsed mass. Excipients such as sugars and polymers can raise the collapse temperature and provide bulk during drying. The critical temperature for primary drying is often the collapse temperature or the glass transition temperature of the maximally concentrated phase. If the product temperature exceeds this threshold, the frozen matrix may soften and lose structure. Established practice therefore links shelf temperature and chamber pressure to the formulation's thermal properties.
| Property | Value | Notes |
|---|---|---|
| Physical state | Solid, porous cake or powder | Depends on formulation and container |
| Typical storage temperature | 2–25 °C, protected from moisture | Some materials require colder conditions |
| Solubility class | Usually readily soluble after reconstitution | Not an intrinsic chemical property |
| Common analytical method | Karl Fischer titration | Used for residual moisture |
| Common synonyms | Freeze-drying; lyophilisation | Lyophilisation is a spelling variant |
Freezing is the first stage and sets the ice structure that later becomes the pore network. The formulation is cooled below its freezing point, often with a controlled ramp, and solutes concentrate as ice forms. Primary drying then lowers chamber pressure and supplies heat to sublime the ice. The product temperature must stay below its collapse or eutectic temperature to prevent structural loss. Secondary drying raises the temperature modestly to remove bound water and achieve a low residual moisture.
A freeze-dryer consists of a vacuum chamber, temperature-controlled shelves, a condenser, and a vacuum pump. Vials, ampoules, or bulk trays hold the product during the cycle. The condenser traps water vapor as ice at a temperature lower than the product. Cycle development balances shelf temperature, chamber pressure, and time. Scale-up can be difficult because heat and mass transfer change with equipment size, so process analytical tools and conservative validation are often used.
Lyophilization is a dehydration process that removes water from a frozen material by sublimation under low pressure. The material is first frozen so that water becomes ice; then the surrounding pressure is lowered below the vapor pressure of ice. Heat is applied gently so ice changes directly to vapor without passing through a bulk liquid phase. The vapor is collected on a cold condenser, leaving a dry porous matrix. This process differs from simple evaporation because the material remains frozen during the main drying stage.
The process usually has three stages: freezing, primary drying, and secondary drying. Freezing sets the ice crystal structure and can determine pore size in the final cake. Primary drying removes free ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, although some water may remain as part of the solid. Cycle parameters depend on formulation, fill volume, vial type, and equipment performance.
He explored this topic in his book Panic Nation (2006), which he co-authored with Stanley Feldman. Marks gained prominence in the medico-legal field, providing expert opinions in notable cases. His testimony in Danish-born British socialite Claus von Bülow's 1985 trial challenged accusations of insulin injection and led to an acquittal. The case was made into a book and later into an Oscar winning movie, Reversal of Fortune. In his testimony, Marks said that the insulin-covered needle was most likely planted by someone who did not realize that insulin is cleaned off the needles once it is injected. Marks also testified against Beverley Allitt in 1993, who used insulin to murder four children, and at the trial of Colin Norris in 2008. In 2007, he co-authored Insulin Murders detailing his involvement in high-profile medico-legal cases and reflecting on his career. The book was among the first to talk about insulin as a murder weapon and documented more than 50 years of medical cases in which insulin had been used as a weapon. Marks retired in 1995 but remained active as an emeritus professor, contributing to research, publishing, and medico-legal work. He served as the president at the Association of Clinical Biochemists between 1989 and 1991, and as the vice president at the Royal College of Pathologists. In a career spanning more than 50 years, he authored over 50 papers, contributed to more than 300 research publications, and authored almost 20 textbooks. His last book, The Forensic Aspects of Hypoglycaemia, was published in 2019.
== History of ITC == The history of ITC can be traced back to the 1930s when isothermal calorimetry was used to study chemical reactions. In 1965 Christensen and Izatt introduced titration calorimetry as a method for simultaneously determining the equilibrium constant and enthalpy. The ITC technique was then developed by H. D. Johnston in 1968 as a part of his Ph.D. dissertation at Brigham Young University, and was considered niche until introduced commercially by MicroCal Inc. in 1988. In 1978, Beaudette and Langerman conducted one of the earliest calorimetric binding studies using a small volume isoperibol titration calorimeter and a decade later, in 1989, Wiseman, Williston, Brandts, and Lin demonstrated its application in biological systems, marking the beginning of titration calorimetry as a valuable tool for studying biological equilibria. Originally, ITC was most often used to study the binding of small molecules (such as medicinal compounds) to larger macromolecules (proteins, DNA etc.) in a label-free environment. Its application has now broadened, aided by modern improvements, making it possible to measure the heat effects as small as 0.1 μcal (0.4 μJ) and determine the binding constants (K) as high as 108–109 M−1.
== Treatment == Avoid cold weather. Treat the underlying lymphoma. No cold drinks; all drinks should be at room temperature (or above). Requires heater to maintain temperature in cold places. Treatment with rituximab has been described. The treatment of cold agglutinin disease depends on many factors including the severity of the condition, the signs and symptoms present in each person, and the underlying cause. For example, in those affected by secondary cold agglutinin disease, it is important to diagnose and treat the underlying condition which may include certain types of cancer; bacterial, viral, or parasitic infections; and/or other autoimmune disease. People with few symptoms and/or mild anemia may not require any specific treatment. These cases are often managed by simply avoiding exposure to the cold. In severe cases of hemolysis, medical interventions may be necessary. Rituximab (an antibody that selectively reduces specific types of immune cells) is effective in about 60% of cases of severe cold agglutinin disease. Medical researchers have found the response to rituximab is seen on average within 1 to 2 months of treatment and the effect of the treatment lasts for about 1 to 2 years. Rituximab may be used after a second and even a third relapse, however the success rate is less. Combined treatment with rituximab and fludarabine has resulted in higher response rates (76% of cases) and longer periods of remissions (on average, 6.5 years).
=== Natural remedies === Studies into treatments to improve low ovarian reserve and low AMH levels have met with some success. Current best available evidence suggests that DHEA improves ovarian function, increases pregnancy chances and, by reducing aneuploidy, lowers miscarriage rates. The studies into DHEA for low AMH show that a dose of 75 mg for a period of 16 weeks should be taken. Improvement of oocyte/embryo quality with DHEA supplementation potentially suggests a new concept of ovarian aging, where ovarian environments, but not oocytes themselves, age. DHEA has positive outcomes for women with AMH levels over 0.8 ng/mL or 5.7 pmol/L. DHEA has no apparent effect on oocytes or ovarian environments under this range. Studies have demonstrated a decline in CoQ levels with age. Studies on CoQ10 supplementation in an aged animal model delayed depletion of ovarian reserve, restored oocyte mitochondrial gene expression, and improved mitochondrial activity. Therefore, CoQ10 is used as a stimulator of the mitochondrial ATP formation in the electron transport chain when it's naturally deficient in ovarian aged patients. Authors note that to replicate the 12–16 weeks of using CoQ10 supplements on mice to achieve these results would be the equivalent to a decade in humans. Vitamin D is believed to play a role in AMH regulation. The AMH gene promoter contains a vitamin D response element that may cause vitamin D status to influence serum AMH levels.
=== Preclinical === Acne vaccine – immunostimulant ADA-308 – antiandrogen (androgen receptor antagonist) Research programme: acne vulgaris therapeutics - Attillaps Pharmaceuticals – acetylcholinesterase inhibitors
Sources: en.wikipedia.org
A hematoma, also spelled haematoma, or blood suffusion is a localized bleeding outside of blood vessels, due to either disease or trauma including injury or surgery and may involve blood continuing to seep from broken capillaries. A hematoma is benign and is initially in liquid form spread among the tissues including in sacs between tissues where it may coagulate and solidify before blood is reabsorbed into blood vessels. An ecchymosis is a hematoma of the skin larger than 10 mm. They may occur among and or within many areas such as skin and other organs, connective tissues, bone, joints and muscle. A collection of blood (or even a hemorrhage) may be aggravated by anticoagulant medication (blood thinner). Blood seepage and collection of blood may occur if heparin is given via an intramuscular route; to avoid this, heparin must be given intravenously or subcutaneously.
Fibroblast activation protein alpha (FAP-alpha) also known as prolyl endopeptidase FAP is an enzyme that in humans is encoded by the FAP gene. Prolyl endopeptidase FAP is a 170 kDa membrane-bound gelatinase. It was independently identified as a surface glycoprotein recognized by the F19 monoclonal antibody in activated fibroblasts and a Surface Expressed Protease (seprase) in invasive melanoma cells.
Experts agree that homemade ORS preparations should include one liter (34 oz.) of clean water and 6 tsp (30 mL) of sugar; however, they disagree about whether they should contain half a teaspoon of table salt or a full teaspoon. Most sources recommend using half a teaspoon of salt per liter of water. However, people with malnutrition have an excess of body sodium. To avoid worsening this symptom, ORS for people with severe undernutrition should contain half the usual amount of sodium and more potassium.
The two substrates of this enzyme are pyridoxal and oxidised nicotinamide adenine dinucleotide (NAD+). Its products are 4-pyridoxolactone, reduced NADH, and a proton. This enzyme belongs to the family of oxidoreductases, specifically those acting on the CH-OH group of donor with NAD+ or NADP+ as acceptor. The systematic name of this enzyme class is pyridoxal:NAD+ 4-oxidoreductase. This enzyme is also called pyridoxal dehydrogenase. This enzyme participates in vitamin B6 metabolism.
Sources: en.wikipedia.org
Studies show that the EPOC effect exists after both aerobic exercise and anaerobic exercise. In a 1992 Purdue study, results showed that high intensity, anaerobic type exercise resulted in a significantly greater magnitude of EPOC than aerobic exercise of equal work output. For exercise regimens of comparable duration and intensity, aerobic exercise burns more calories during the exercise itself, but the difference is partly offset by the higher increase in caloric expenditure that occurs during the EPOC phase after anaerobic exercise. Anaerobic exercise in the form of high-intensity interval training was also found in one study to result in greater loss of subcutaneous fat, even though the subjects expended fewer than half as many calories during exercise. Whether this result was caused by the EPOC effect has not been established, and the caloric content of the participants' diet was not controlled during this particular study period. Most researchers use a measure of EPOC as a natural part of the quantification or measurement of exercise and recovery energy expenditure; to others this is not deemed necessary. After a single bout or set of weight lifting, Scott et al. found considerable contributions of EPOC to total energy expenditure. In their 2004 survey of the relevant literature, Meirelles and Gomes found: "In summary, EPOC resulting from a single resistance exercise session (i.e., many lifts) does not represent a great impact on energy balance; however, its cumulative effect may be relevant".
=== Alternatives to cement used in antiquity === Cement, chemically speaking, is a product that includes lime as the primary binding ingredient, but is far from the first material used for cementation. The Babylonians and Assyrians used bitumen (asphalt or pitch) to bind together burnt brick or alabaster slabs. In Ancient Egypt, stone blocks were cemented together with a mortar made of sand and roughly burnt gypsum (CaSO4 · 2H2O), which is plaster of Paris, which often contained calcium carbonate (CaCO3),
== Side effects == The most common adverse effects are blurred vision, tearing and other kinds of eye discomfort. Eye pain, eye oedema, headache, increased intraocular pressure and other side effects are seen in less than 1% of patients.
Sources: en.wikipedia.org
Freezing only converts liquid to solid. Lyophilization adds vacuum and controlled warming so frozen solvent sublimes, leaving a dry porous solid. The two steps are related but not interchangeable.
Reduced pressure keeps the solvent below its triple point, allowing ice to become vapor without melting. Vacuum also helps remove water vapor from the product chamber. The exact pressure is chosen with the formulation and equipment.
Residual moisture is water that remains in the dried solid after secondary drying. It is often measured by Karl Fischer titration, near-infrared spectroscopy, or thermogravimetry. Acceptable levels depend on the material and its stability profile.
Primary drying removes ice by sublimation at low pressure and low shelf temperature. Secondary drying removes bound water by raising the shelf temperature, often under the same vacuum. The two stages differ in the water state being removed.